System Configuration; Operation - REMKO KWL 130 Operation Manual

System configuration

System configuration
Indoor area 1
Condensate drain
Chilled water -
appliance
Infrared remote control
Outdoor area
Chiller
Condensate line (only
units with HP-function)

Operation

The system can be easily operated
via the fully automatic iChiLL
controller. If due to local conditions
programming via the internal
control can only be realised with
difficulty, the system can also be
controlled via a cabled remote
control (accessory) or an external,
potential-free, enabling contact
(standard).
A centralised fault contact, part of
the standard equipment, can be
used for the external signalling of
a fault.
CAUTION
!
If the letter "A" is shown in the display with a two-digit numeric
code, there is a fault in the chiller.
(see chapter on trouble-shooting and customer service).
Indoor area 2
Condensate drain
Chilled water -
appliance
Room temperature control
v
Methods of operation
Enabling contact
On/OFF Cooling/Heating
(e.g. building management
system)
(Standard equipment)
Indoor area 3
Condensate drain
Condensate collecting pipe
Chilled water -
appliance
Cabled remote control
Medium outlet
Medium intake
Cable
remote control
(Accessories)
The unit is designed as a 2 conduc-
tor system.
The system has 2 medium pipes
(conductors: supply and return)
for cooling using a cold medium
(KWL) or heating using a warm
medium (units with HP function
KWL...H).
In combination with a correspond-
ing system, the output can be
transmitted to the room to be
cooled via the floor, the building
structure or by means of ceiling
cooling.
For each of the different systems,
a minimum flow volume and
a minimum medium volume must
be ensured for the plant.
iChiLL controller
(Standard
equipment)
Centralised
fault signal
(Standard equipment)
TIP
Help save on energy consump-
tion in stand-by mode! If the
device, system or component
is not in use, we recommend
disconnecting the power sup-
ply. Components with a safety
function is excluded from our
recommendation!
7