Test Mode; How To Enter The Test Mode; Test Menu - CAS PDI Series Manual

Note 1. To set values to the same as the factory default for the indicator, press the setup key after setting F99 to 1.

6. Test Mode

6-1. How to Enter the Test Mode

Test mode starts when the power is turned on while pressing
of the indicator.
Press the number for the test menu as you wish.
To exit the TEST mode, press
turn on the power again.
6-2. Test Menu (TEST 1 – TEST4)
Test 1: Key test
Test 2: Display test
Test 3: Load cell test and A/D conversion test
Test 4: RS-232 serial communication test (COM1, COM2)
Test 1
Function: Key test
Used key
: Test value change
: Test / Move to next menu
<Key List>
Key number
62
key for a long time (turn off the power) and
Display
KEY 1
Key number Key
60
3 4
Descriptions
When you press any key to test, the number
and code for the key are displayed on the
screen.
number Key
27
key in the front
number
30