Undesired Input State Message - Globalstar SmartOne Series User Manual

7
8
8
8
8
8
8

Undesired Input State Message

This is the message that is transmitted when the user has selected for
an undesired input state to cause a different report rate. When this
Mode is enabled, the user defined Undesired Input State report rate
supersedes the At Rest and In Motion report rates when the input(s) is
(are) in an undesired state. The Sub-Type value of this message is 4.
The Input Status portion of byte 7 will indicate which input(s) are in
SmartOne Manual Rev 1.5
Standard Message
Sub-Type
RESERVED
Vibration
triggered message
Vibration bit.
2D
Motion
Fix Confidence
Bit.
Table 5 – Input Status Changed Message
Bit 0: Input 1 change: 0 =
Did not trigger message, 1 =
Triggered message.
Bit 1: Input 1 state:
Closed, 1 = Open
Bit 2: Input 2 change: 0 =
Did not trigger message, 1 =
Triggered message
Bit 3: Input 2 state:
Closed, 1 = Open
Bits (7:4) Standard message
sub-type code.
4
the Input Status Changed
message.
3 Bits (2:0) RESERVED in SmartOne
Bit (3) – Value 1 = This
message is being sent because
transmit on change of vibration
state is selected and the
vibration just changed state,
1 or Undesired Vibration state is
selected and the vibration is
in the undesired state.
0 = This message is being
transmitted for a reason other
than the above reasons.
Bit (4) – Value 1 = Unit is in
a state of vibration.
1
= Unit is not in a state of
vibration.
Bit (5) – Value 1 = GPS data
reported is from a 2D fix.
1 (Only 3 satellites were used in
the fix.) Value 0 = GPS data
reported is from a 3D fix.
Bit (6) – Value 1 = Device was
In-Motion when the message was
1 transmitted.
was At-Rest when the message
was transmitted.
Bit (7) 0=High confidence in
1 GPS fix accuracy, 1=Reduced
confidence in GPS fix accuracy.
DOC# 9100-0268-01
0 =
0 =
Value is 3 in
Value
Value 0
Value 0 = Device
p.54