Globalstar SmartOne Series User Manual page 41

Message Interval inside the Change of Location Area. The SMARTONE can be
configured to transmit messages while inside its Change of Location
Area. This parameter allows you to configure the message interval inside
the Change of Location Area in days, hours and minutes. In Theft
Recovery Mode, the asset will send infrequent messages, user
configurable interval, if asset is in its Change of Location Area.
Position Check Interval while in State of Vibration. The SMARTONE can be
configured to check GPS coordinates at a rate different from the
transmission rate. This interval will determine the accuracy in time on
how quickly the device will sense that it has left its authorized Change
of Location Area.
The SMARTONE has the ability to get GPS fixes without transmitting the
information to Globalstar Simples network. It uses the information to
confirm if it is inside its Change of Location Area.
Vibration Sensor Settings Button. This button activates the Vibration
Settings window. This window contains settings to define how the
vibration sensor determines that the SMARTONE is In Motion. The
parameters include Level of Sensitivity for Vibration Sensor and Time to
be in a State of Vibration and the Time to be in a State of Lacking
Vibration.
Level of Sensitivity for Vibration Sensor. The vibration sensor has a
range of sensitivity from 1 to 31 (1 most sensitive and 31 least
sensitive). The smaller the sensitivity level, the more sensitive the
vibration sensor would be to movement.
Time to be in a State of Vibration. Time the vibration sensor must be
above the sensitivity level before being in a State of Vibration. If the
device senses continuous vibration for a period of time less than the
specified in this parameter, the device will ignore the vibration and
will not enter into a State of Vibration
SmartOne Manual Rev 1.5 DOC# 9100-0268-01 p.41