Replace Battery Message; Contact Service Provider Message - Globalstar SmartOne Series User Manual

Replace Battery Message

The Replace Battery message has a format almost identical to the
Diagnostic message. If enabled by the user, the Replace Battery message
will be sent by the SMARTONE when the battery charge level is at or
below the replace battery advisement level. The message will be
repeated at an interval configurable by the user for as long as the
battery remains below the advisement level. The default configuration
is for the Replace Battery message to be enabled and to be transmitted
once per day when the battery is low. The format of the Replace Battery
message is shown in table 9.
Byte Number Variable
0
Type Field
0
Subtype
1
Number of
transmissions
per burst.
1 Battery
Condition
1 GPS Subsystem
Fault
1 Transmitter
Subsystem Fault
1 Scheduler
Subsystem Fault
2
Min Interval
3
Max Interval
4
GPS Mean Search
Time
5,6
# GPS Fails
7,8
# Transmissions

Contact Service Provider Message

The SMARTONE will send a Contact Service Provider message when an
internal fault is detected. The SMARTONE will send one such message
upon the detection of an internal fault. It will then attempt to
continue to operate normally. The SMARTONE will not send another
SmartOne Manual Rev 1.5
Bits Description
Bit (1:0) = 3 Non Standard
2
message type:
Bit (7:2) = 22 for Replace
6
Battery Message.
Bits(3:0) = Number of
Transmissions (1 to 15
4
Transmissions)
Bit 4: 0 = Good battery. 1 =
1
Replace Battery
Bit 5: 0 = GPS system OK. 1 =
1
Fault
Bit 6: 0 = Transmitter OK. 1 =
1
Fault.
1 Bit 7: 0 = OK. 1 = Fault
Minimum Interval between
transmission attempts ( 5
8
second resolution) Default is
300 seconds
Maximum Interval between
8 transmission attempts, Default
is 600 seconds
Unsigned binary count in
8 seconds for mean GPS search to
acquire
Unsigned binary count of
16 failed GPS attempts since last
Diagnostic message
# of transmissions since last
16
Diagnostic message
Table 9 - Replace Battery Message
DOC# 9100-0268-01 p.62