Re-Center Message - Globalstar SmartOne Series User Manual

8
8
8
8
8
8

Re-Center Message

The Re-Center message is transmitted when Reduced Messaging Mode is
selected and the SMARTONE re-centers (automatically sets a new Change of
Location Area). The subtype value of this message is 5. The message
format is shown in table 7.
Byte Number
0
0
0
0
SmartOne Manual Rev 1.5
RESERVED
Vibration
triggered message
Vibration bit.
2D
Motion
Fix Confidence
Bit.
Table 6 - Undesired Input State Message
Variable
Type field
Battery state
GPS Data Valid
Missed Input State
Change
the undesired input state
message.
3 Bits (2:0) RESERVED in SmartOne
Bit (3) – Value 1 = This
message is being sent because
transmit on change of vibration
state is selected and the
vibration just changed state,
1 or Undesired Vibration state is
selected and the vibration is
in the undesired state.
0 = This message is being
transmitted for a reason other
than the above reasons.
Bit (4) – Value 1 = Unit is in
a state of vibration.
1
= Unit is not in a state of
vibration.
Bit (5) – Value 1 = GPS data
reported is from a 2D fix.
1 (Only 3 satellites were used in
the fix.) Value 0 = GPS data
reported is from a 3D fix.
Bit (6) – Value 1 = Device was
In-Motion when the message was
1 transmitted.
was At-Rest when the message
was transmitted.
Bit (7) 0=High confidence in
1 GPS fix accuracy, 1=Reduced
confidence in GPS fix accuracy.
Bits Description
Bit (1:0) = 0 = Standard
2 message type:
Bit (2) 0 = Good battery.
1
replace battery.
Bit (3) 0 = GPS Data valid in
this message.
1
in this message cycle, ignore
Latitude and Longitude fields.
Bit (4) Missed Input 1.
value of 1 in this bit means
that an input state change of
Input 1 was missed due to the
2 transmission of a higher
priority message.
Bit (5) = Missed Input 2.
value of 1 in this bit means
that an input state change of
DOC# 9100-0268-01
Value
Value 0
Value 0 = Device
1 =
1 = GPS failed
A
A
p.56