Control Module; Installation - Graco E-Flo 24P821 Instructions-Parts List Manual

Control Module

Control Module Module
Control Control Module
The Control Module provides the interface for users to enter selections and view information related to setup
and operation.
The screen backlight is factory set to remain on, even without screen activity. See
set the brightness and backlight timer. Press any key to restore the settings.
Keys are used to input numerical data, enter setup screens, navigate within a screen, scroll through screens,
and select setup values.

Installation

Installation Installation
Install Install the Install the Control the Control Module Control
1. Shut off and lock out power to the motor.
2. For single phase models only, install the jumper
connector (5) over the top two terminals of the
motor, using the screw (5a). Three phase models
do not have a jumper connector.
NOTE: To connect up to 8 motors together,
NOTE: NOTE:
see Appendix A in the E-Flo DC Motor Manual
(3A2526), where the control module is the
referenced intrinsically safe (IS) apparatus.
NOTE: See Appendix C for information about
NOTE: NOTE:
different multi-unit topologies.
Figure 1 Install the Control Module (Single Phase
Model Shown)
4
Module Module
3. Assemble the bracket kit (6a-6f) and the holder
and tie (11, 12) as shown.
4. Install the module (1) in the bracket (6a), making
sure the tabs at the bottom of the bracket engage
the slots in the module, and the lip at the top of
the bracket holds the module securely in place.
5. Connect the accessory cable (C), using the
tie (12) as a strain relief as shown. See
Cable Connection, page 5
6. Restore power to the motor.
Setup Screen 18, page 20
.
3A2527H
to