Setup Screen 5 - Graco E-Flo 24P821 Instructions-Parts List Manual

Setup Screen Screen 5 5 5
Setup Setup Screen
Use this screen to set the lower pump size (cc) of
each pump. The default is blank; select the correct
lower size, or custom. If custom is selected, enter the
size of the lower in cc. This screen also activates jog
mode, allowing you to position the motor/pump shaft
for connection or disconnection.
NOTE: The motor will limit its pressure output when NOTE: NOTE:
the selected lower is 750cc, to prevent exceeding the
pressure rating of the lower.
Figure 15 Setup Screen 5
Setup Screen Screen 5 5 5 Key
Setup Setup Screen
For systems with multiple pumps and
one display, select the pump (1 to 8)
from the menu.
NOTE: Three phase systems do not
support multiple pumps.
Select to enable jog mode. Use the
arrow keys to move the motor or
pump shaft up or down.
Select the correct pump lower size
from the menu. The default is blank.
If custom is selected, a field opens
for you to input the size of the lower
in cc.
• Supply pumps
– 145 cc
– 180 cc
– 220 cc
– 290 cc
• Circ pumps
– 750 cc*
– 1000 cc
– 1500 cc
– 2000 cc
– 2500 cc
* When 750 cc is selected, the
maximum force is capped to 75%
to prevent over pressurizing the
pump.
3A2527H
Key
Key
Setup Screen Screen 6 6 6
Setup Setup Screen
Use this screen to view the grand totalizer value and
to set or reset the batch totalizer.
Figure 16 Setup Screen 6
Setup Screen Screen 6 6 6 Key
Setup Setup Screen
For systems with multiple pumps and
one display, select the pump (1 to 8)
from the menu.
NOTE: Three phase systems do not
support multiple pumps.
Displays the current grand total of pump
cycles. This field cannot be reset.
Displays the batch total in selected
volume units.
Resets the batch totalizer to zero.
Setup Screens
Key
Key
15