Table of Contents
Advertisement
Operation
If the certification data log is full, it can be deleted using the command
"ClCDL" if the calibration lock is open (see chapter 5.3.1.16).
If the calibration lock is opened when the certification data
log is full, it can only be closed again after the certification
data log has been deleted.
6.3.6.3
Administrator and customer locks
Administrator and customer locks are used to protect data which is not
subject to calibration regulations, but which should also not be modified
without authorization.
These locks can be opened by entering a code (i.e. the "key") under
"Cod.A" or "Cod.C" and are closed by entering "0" for "St.AL" or "St.CL".
These values can be found under the following path:
Admin
or
Serv.
Device settings
A time (in minutes) can also be set here for each lock, after which it will
automatically close.
Device settings
Access
Access
71
Advertisement
Table of Contents
