Operation - HomeMatic HmIPW-WTH Installation Instructions And Operating Manual

Operation

receiving the command.
• Select the
and confirm by pressing the control wheel briefly.
The connection test is carried out.
7 Operation
After configuration, simple operations are available di-
rectly on the device.
If the wall thermostat is in standby mode, please
press the control wheel (E) once before operation
to activate the device.
• Temperature: Turn the control wheel (E) to the
right or to the left to manually change the tem-
perature. In automatic mode, the manually set
temperature will remain the same until the next
point at which the profile changes. Afterwards,
the defined heating profile will be activated again.
During manual operation, the temperature re-
mains activated until the next manual change.
74
symbol by turning the control wheel