Configuring The Floor Heating Actuator; Communication Test - HomeMatic HmIPW-WTH Installation Instructions And Operating Manual

6.9

Configuring the floor heating actuator

You can use this menu item for configuring your Home-
matic IP Wired Floor Heating Actuator.
• Select the
wheel and confirm by pressing the control wheel
briefly.
• If the wall thermostat is connected to more than
one floor heating actuator, please select the re-
quired floor heating using the control wheel.
• Please define if you want to configure the device
parameters ("UnP1/UnP2") or the channel param-
eters ("ChAn").
• You can individually adjust the line-up time/fol-
low-up time, eco temperatures, intervals etc.
For further information regarding the configuration op-
tions, please refer to the user manual of the Homemat-
ic IP Floor Heating Actuator.
6.10

Communication test

You can check the connection between your Homematic
IP Wired Wall Thermostat and the Homematic IP Wired
Floor Heating Actuator. During this test, the wall thermo-
stat transmits a switching command to the floor heating
actuator. Depending on the current status of the actua-
tor, the device is switched on or off for confirmation after
firm by pressing the control wheel briefly.
Operating modes and configuration
symbol by turning the control
73