Installation; Installation In Multiple Combinations - HomeMatic HmIPW-WTH Installation Instructions And Operating Manual

Wired wall thermostat with humidity sensor

Table of Contents

Available languages

5.2

Installation

The bus is supplied by the Homematic IP Wired

Access Point (HmIPW-DRAP). For further infor-

mation, please refer to the operating manual of

the Wired Access Point.

For the installation, please proceed as follows:

•

Connect the Homematic IP Wired bus to the bus

connecting terminals (G) (see fig. 3). For connec-

tion and removal of individual wires, use a small

screwdriver to press down the orange clamp.

•

Place the mounting plate (F) into the flush-

mounted box and fix it to the flush-mounted box

using the supplied screws (see figure 4).

•

Place the frame of your existing switch series or

the supplied clip-on frame (A) on the mounting

plate (A) (see figure 5).

•

Place the electronic unit (B) of the wall thermo-

stat into the frame, by properly engaging the

connection pins (H) into the appropriate bracket

of the mounting plate (see figure 6+7).

5.3

You can mount the wall thermostat with the attachment

frame (A) provided or use it with frames of other

manufacturers as well as integrate the electronic unit

(B) into a multi-gang frame. For mounting with multiple

combinations, make sure that the mounting plate of the

Start-up

Table of Contents

Table of Contents