Linking The Floor Heating Actuator; Communication Test; Operation - HomeMatic HmIP-WTH-1 Installation And Operating Manual

6.9

Linking the floor heating actuator

To use a Homematic IP floor heating actuator with the Homematic IP wall
thermostat, it must first be taught to the Homematic IP Access Point and
then linked to the wall thermostat.
For more information on the configuration options, please refer to the
operating instructions of the Homematic IP floor heating actuator and
the Homematic IP user manual.
6.10

Communication test

You can check the connection between your Homematic IP Wall Ther-
mostat and the Homematic IP Floor Heating Actuator. During this test,
the wall thermostat transmits a switching command to the floor heating
actuator. Depending on the current status of the actuator, the device is
switched on or off for confirmation after receiving the command.
Press and hold down the control wheel (E) to open the configu-
•
ration menu.
• Select the
pressing the control wheel briefly.
7

Operation

After configuration, simple operations are available directly on the device.
If the wall thermostat is in standby mode, please press the control
wheel (E) once before operation to activate the device.
• Temperature: Turn the control wheel (E) to the right or to the
left to manually change the temperature. In automatic mode,
the manually set temperature will remain the same until the next
point at which the schedule changes. Afterwards, the defined
heating schedule will be activated again. During manual oper-
ation, the temperature remains activated until the next manual
change.
• Boost function for Homematic IP Radiator Thermostats: Press
the control wheel (E) of the wall thermostat briefly to activate
symbol by turning the control wheel and confirm by
Operation
41