Setting The Date And Time "Dat; Actuator Status Query "Vst; Shutter Contact Status Queries "Wst - HomeMatic HM-CC-TC Installation And Operating Manual

Radio-controlled

Hide thumbs Also See for HM-CC-TC:

Table of Contents

Available languages

Shut down the time program by setting 00:00 hrs. as the end

time. 00:00 is automatically set as the end time, if 24 temperature

phases have been created.Program completion is indicated on

the display with "OK".

8.2

Setting the date and time "DAT"

Call up special function "DAT". Press the "OK" button to set the

time and date. Proceed as described previously in section "Start

up".

8.3

You can show the opening status of the actuator, the battery sta-

tus and the status of the radio connection under this menu point.

Call up special function "VST".

Press the "OK" button to call up the information on the actuators.

The valve opening is indicated as a percentage on the display. If

the battery is low, the battery symbol will also be shown. If the

radio connection between the valve drive and the controller is

interrupted, the antenna symbols will also ﬂash. Use the setting

dial to switch between the taught actuators.

8.4

You can query the current status of the shutter contacts or the

door window rotary handle sensors under this menu point.

Call up special function "WST".

Table of Contents

Do you have a question about the HM-CC-TC and is the answer not in the manual?