Iaq Reminders; Customizable Reminders - Honeywell TH8321 Product Data

VISIONPRO® 8000 SMART THERMOSTAT
Lockout in Sleep
Period:
Fig. 176.
NOTE: If set up for humidification in heat mode, the venti-
lator will turn on to remove excess humidity if 10%
or more above your humidity setting.

IAQ REMINDERS

You can set up IAQ reminders in the thermostat to remind
users when filters, pads, bulbs, etc. need cleaning or
replacement. The following reminders can be set:
• Air Filter 1
• Air Filter 2
• Humidifier Pad
• Humidifier Clean Tank / Water Filter
• Dehumidifier Filter
• Ventilator Core
• Ventilator Filter
• Electronic Air Cleaner Pre-Filter
• Electronic Air Cleaner Cells
• Electronic Air Cleaner Post-Filter
• UV Bulb 1
• UV Bulb 2
Reminders that are displayed under Preferences will
change based on the IAQ equipment installed. Reminders
for equipment that is already set up can be set using the
steps below. Reminders for IAQ equipment that is not yet
set up must be turned on from the installer setup.
NOTE: Air Filter, Humidifier Pad, Dehumidifier Filter, and
Ventilator Filter are displayed under Preferences
even if they have not been set up. Humidifier Pad
is not displayed if a steam humidifier has been
installed.
Some screens shown in this section may be different from
those on the thermostat, depending on how you set up IAQ
equipment.
1. Press MENU, then scroll to select Preferences.
2. Press Reminders. Fig. 177 is displayed.
Fig. 177.
33-00096—04
No
MCR34137
3. Select the reminder you want to set.
 
4. Press or to set the timer length. Ranges, incre-
ments, and units will change based on the reminder.
NOTE: When set for run time days, the thermostat
tracks the amount of time the fan has run
and compares that time against the number
of run time days selected. Fan run time is
counted when there is a call for forced air
heating, cooling, or fan.
5. Press Done to save the reminder.
6. Press Reset Timer when you have completed the rec-
ommended maintenance or you can extend the timer
setting to turn off the alert and remind you later to do
the recommended maintenance.
7. Repeat these steps for all reminders you want to set.

CUSTOMIZABLE REMINDERS

The thermostat can be set to alert the user when it is time
for system maintenance or warranty renewal. You can set
up to 10 total Custom Reminders on the thermostat.
Custom Reminders include:
• Service Reminder
— Set up for recurring or one time only.
• Spring Service Reminder
— Provide an alert based on date or outdoor tem-
perature.
• Fall Service Reminder
— Provide an alert based on date or outdoor tem-
perature.
• Warranty Reminder
— Set up for recurring or one time only.
• New Custom Reminder
— Enter new reminders or advertisements
— Set up for recurring or one time only.
72
Fig. 178.