Configure The Drive; Set The Network Parameters; Studio 5000 Logix Designer; Version History - Allen-Bradley Kinetix 5500 User Manual

Configure the Drive

Studio 5000 Logix Designer

You can include the drive in your Studio 5000 Logix Designer® application by
adding it to a configured EtherNet/IP module or controller under the I/O
configuration tree. After setting network parameters, you can view the drive
status information in Studio 5000® environment and use it in your Logix
Designer application.

Set the Network Parameters

You must program network parameters by using the LCD display.
1. From the LCD display, select SETUP>NETWORK and choose
between STATIC IP and DHCP.
The default setting is STATIC IP.
2. If STATIC IP, then press
• IP address
• Gateway
• Subnet mask
Settings are stored in nonvolatile memory. IP addressing can also be changed
through the Module Configuration dialog box in RSLinx® software. Changes
to the IP addressing take effect after power is cycled. The drive is factory
programmed to static IP address of 192.168.1.1.
Refer to Setup Screens
For help using the Studio 5000 Logix Designer application as it applies to
configuring the ControlLogix® or CompactLogix™ controllers, refer to
Additional Resources on

Version History

Each release of the Studio 5000 Logix Designer application makes possible the
configuration of additional Allen-Bradley® motors, actuators, and drive features
not available in previous versions.
IMPORTANT To configure these additional drive features with your Kinetix 5500 servo
drive, you must have drive firmware 4.001 or later. Refer to
determine if you need to install the Kinetix 5500/5700 Add-on Profile.
Rockwell Automation Publication 2198-UM001I-EN-P - May 2019
Configure and Start the Kinetix 5500 Drive System
to configure the following parameters:
on page 110 for help setting the network parameters.
page 12.
Chapter 6
Table 54 to
113