F011 Initial Torque (Vr) Of Ramp; F012 Initial Torque (Cr) Of Ramp; F013 = Accel Ramp Time Of Ramp 1; F014 = Max Current Limit Of Ramp 1 - Toshiba TE2 Series Instruction Manual

TE2 Series Digital Solid State Soft Starter User Manual
F011 = Initial Voltage of Ramp 1
Factory Setting = 60%
Range = 0 - 100%
Sets the initial voltage of Ramp 1 when F010 = 1 or 3. The
initial voltage level should be set to provide just enough torque
to make the motor shaft begin to rotate while preventing torque
shock damage to mechanical components.
F012 = Initial Current of Ramp 1
Factory Setting = 200%
Range = 0 - 600%
Sets the initial current of Ramp 1 when F010 = 2 or 4. The
initial current level should be set to provide just enough torque
to make the motor shaft begin to rotate while preventing torque
shock damage to mechanical components.

F013 = Accel Ramp Time of Ramp 1

Factory Setting = 10 seconds
Range = 1 - 120 seconds
Sets the time between the initial value set with F011 or F012
and either the Max Current Limit set with F014 or full output
voltage. Set the time to enable soft starts without stalls. Also,
consider the motor's application. For example, centrifugal
pumps may require a shorter ramp time.
 Note:
Acceleration time is affected by the following conditions:
1. Reducing the Current Limit setting will extend the acceleration time
if the motor reaches full speed prematurely.
2. The anti-oscillation circuit may shorten the ramp time if the motor
reaches full speed before the programmed ramp time has expired.

F014 = Max Current Limit of Ramp 1

Factory Setting = 350%
Range = 200 - 600%
Sets the maximum motor current that the TE2 Series starter will
allow during Ramp 1. This limit applies to both voltage and
current ramping. Current will be limited to this setting until either
the motor reaches full speed or the overload protection feature
trips (F003).
40 | P a g e