Toshiba TE2 Series Instruction Manual page 7

Basic Installation and Operation Guide
Equipment Warning Labels
DO NOT attempt to install, operate, perform maintenance, or dispose of this equipment, until you have
read and understood all of the product labels, and user directions, that are contained in this manual.
Warning labels that are attached to the equipment will include the exclamation mark within a triangle.
DO NOT remove or cover any of these labels. If the labels are damaged or if additional labels are
required, contact the Toshiba Customer Support Center.
Labels attached to the equipment are there to provide useful information or to indicate an imminently
hazardous situation that may result in serious injury, severe property and equipment damage, or loss of
life if safe procedures or methods are not followed as outlined in this manual.
Qualified Personnel
Installation, operation, and maintenance shall be performed by Qualified Personnel ONLY. A Qualified
Person is one that has the skills and knowledge relating to the construction, installation, operation, and
maintenance of the electrical equipment and has received safety training on the hazards involved (Refer
to the latest edition of NFPA 70E for additional safety requirements).
A qualified person must:
1) Read this entire manual carefull.
2) Be skilled in the installation, construction and operation of the starter, the equipment being driven,
and the hazards involved.
3) Be able to recognize and properly address hazards associated with the application of motor-driven
equipment.
4) Be trained and authorized to safely energize, de-energize, clear, ground, lock-out/tag-out circuits and
equipment, and clear faults in accordance with established safety practices.
5) Be trained and authorized to perform the service, maintenance or repair of this equipment.
6) Be trained in the proper care and use of protective equipment such as safety shoes, rubber gloves,
hard hat, safety glasses, face shield, flash clothing, etc., in accordance with established safety practices.
7) Be trained in rendering first aid.
For further information on workplace safety, visit www.osha.gov.
Safety Codes
WARNING! All installations must comply with all applicable state and local codes.
TE2 Series Digital Solid State Soft Starters 18 – 1250A
In the United States, installations must adhere to all applicable National Electric
Code (NFPA 70) standards.
Installations must follow all instructions provided in this manual.
Failure to follow all applicable codes, standards, or the instructions in this manual
May cause accidents resulting in death or severe injuries.