Overhead Lifting; Initial Inspection; Location; Storage - Toshiba JK Series Instruction Manual

Basic Ins stallation a
Overhead Lif O fting
W When it is necessary t
elevations, ov e verhead hoist
( for multiple controller se
e enclosure for this purpose
to o provide the e vertical lift o
b bolt failure. A Always keep
S Some contro oller sections
equipment tha e at will cause t
R Rigging length hs should be
an upright po a osition. The a
v vertical should d not be allo
R Ropes or cab bles should n
a angles or eye e-bolts. Sling
a adequate load d rating shoul
I nitial Inspec tion
• Make a co omplete visua
may have occurred du
attempt to continue ins
damaged.
• Check for loose mech
which may y have occurre
Loose ele ctrical conne
cause the unit to functio
• Prior to beg ginning the in
JK unit are rated for the

LOCATION

L N

Storage

S
If f the controlle er is to be sto
s should be res stored for pr
p packing shoul ld be left intac
p packing (Fig. 4) is removed
during the con d nstruction per
I ndoor Equip pment
Controllers de C esigned for ind
a and energized d immediately
t emperature p prevents cond
heated buildin h ng, with ade
Equipment sh E hould be store
TOSHIBA T
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
and Operat tion Guide
to move the e equipmen
ting may be required. Lift
ctions) are p provided on
e. Spreaders (Fig. 2) shou
on single con ntrollers to pr
the controll er upright w
s may cont tain heavy
the center of gravity to be
adjusted to m maintain the c
angle betwee n the lifting c
owed to excee ed 45 degree
not pass thro ough the hole
gs with safety y hooks or s
d be used.
l check of the e unit for dam
uring shipping g and handlin
stallation or s start up the
hanical assem mblies or bro
ed during tran nsportation or
ections will in ncrease resis
on improperly .
nstallation, ve rify that the lo
proper ampe rage and volt
ored for any length of time
rotection duri ng that perio
ct until the co ontroller is at t
d, the top and d openings of
riod to protect t it against du
door installati ion (e.g. Type
y should be stored in a c
densation. Pr referably, the
equate air cir rculation and
ed where it is not subject to
JK 72
t between
ting angles
top of the
ld be used
revent eye-
while lifting.
or special
e off-center.
controller in
cables and
es (Fig. 3).
es in lifting
shackles of
F Fig. 2 Use of
mage which
ng. Do not
unit if it is
oken wires
r handling.
stance and
oad and
tage.
Fig. 3 Li
e prior to inst tallation, the
od. Where co onditions per
the final insta allation positio
f the controlle er should be
ust and debris s.
e 1, 12) that a are not to be i
clean, dry spa ace where a
e controller sh hould be sto
d protected f from dirt and
o mechanical damage, esp
20 Series C Controllers
f Spreader B Bar - Single S
ifting Multipl le Sections
packing
rmit, the
on. If the
covered
installed
uniform
red in a
d water.
pecially
Fig. 4 Storag
s
Section
ge
2