Toshiba TE2 Series Instruction Manual page 12

Type of Load:
AC Supply Voltage:
Power Ratings:
Unit Capacity - Continuous
Unit Capacity - Overload Rating
(Percent of motor FLA)
Power Circuit
SCR Firing Angle Detection
SCR PIV Ratings
(Peak Inverse Voltage)
Transient Protection
Cooling
Bypass Contactor
Bypass Contactor Rating
Bypass Contactor Control
Ambient Condition Design
Control Power
Inputs
Programmable Relay Outputs
Output Relay Contact Rating
Programmable Analog Outputs
Dedicated Fault Output
Approvals
TE2 Series Digital Solid State Soft Starter User Manual
1.1.3 Design Specifications
Three - phase AC induction motors.
Universal, 208 - 600VAC ±10%, 50/60 Hz.
9 - 1250 Amps, 7.5 - 1000 HP @ 460V.
Max. Amp rating is UL Listed continuous rating.
500% - 60 seconds.
6 SCRs, full phase angle firing using a hard fire firing circuit to avoid motor
transient problems.
6 pulse Independent Locked Phase Tracking with Auto-synchronization,
prevents misfiring on unstable source frequency.
1600V
RC snubber dV/dt networks on each phase.
Fan assisted convection.
Standard on all units.
Shunt rated or can be sized for Line start rating.
Integral control is included, but contactor can be externally controlled as well.
0° to 40°C (32° to 122°F)
5 - 95% relative humidity.
0 - 3300 ft. (1000m) above sea level without derating.
120VAC (customer supplied), 240VAC optional.
6 Dry (voltage free) contact inputs using 24VDC from an internal power supply.
3 relays, 2 each Form C (SPDT), 1 each Form A (SPST).
Can be programmed for 32 functions, with delays or flashing.
5 Amps, 240VAC max. (1200VA).
1 analog output 4-20mA
Can be programmed for 12 functions with scaling.
AC Triac solid state switch.
240VAC, 50mA max.
UL Listed, Canadian UL (cUL) Listed CE Approved. UL 60947-4-2
3 | P a g e