Van Raam Chat User Manual page 31

Setting the steering
In order to realise optimal steering behaviour
and minimal tyre wear, the steering must be set
correctly.
1. Loosen the left and right nuts of the steering
shaft [A].
Please note! This is a nut with a left wire and
a nut with a right wire.
2. Subsequently turn the steering shaft to
adjust the tracking of the wheels. The
wheels must be set parallel.
3. Tighten the nuts of the steering shaft again.
4. Loosen the two nuts of the steering shaft [B].
Please note! This is a nut with a left wire and
a nut with a right wire.
5. Make sure the steering stop is in the middle
of the steering plate [C].
6. Subsequently move the steering shaft to
ensure that the wheels face straight ahead
when the steering stop is in the middle of
the steering plate.
7. Tighten the nuts of the steering shaft again.
8. Finally point the handlebar straight ahead.
Make sure the wheels also face straight
ahead at that moment.
9. Check whether the tricycle easily drives
straight ahead on the tyres, without
resistance and friction.
User Manual | Chat 19.06
[A]
[B]
[C]
30