Van Raam Chat User Manual page 16

With the option "integrated lighting", the lights will automatically switch on when you turn
on the electric motor system. You can switch the lights on and off by briefly pressing the
on/off button in this mode.
Always turn off the electrical system when you are
getting off the tricycle. Turn the electrical system on
after you have taken up your riding position.
Make sure that the switch under the luggage carrier is
always pressed to the side where the battery is
located. Note that with some models the battery
switch has a middle (neutral) position as well. That
means the battery is switched off.
2. Degree of support 1, 2 and 3
The desired support can be set by using one of the support levels 1, 2 or 3.
1. Light support, maximum range.
2. Average support, average range.
3. Maximum support, low range.
You can change the level while cycling.
3. Start assist
The Silent electric motor has a start support. This allows the driver to pull-away without
pedalling up to a speed of 6 km/h over five seconds. To accelerate, press the start assist
button and keep it pressed down. The function will only activate again, when the s upport
button has been pressed down again.
If you peddle normally, the function works for up to five seconds, each time the button is
pressed, up to maximum speed of the tricycle (20-25 km/h).
The start assist is used for:
Extra support when starting.

Extra support for cycling uphill.

Tip: when cycling a steep climb, you can use support in level 3 and push the start assist
repeatedly for five seconds to achieve maximum support.
User Manual | Chat 19.06
15