Advertisement
5b.
Set application mode
6.
Creating zones in a group
Up to 16 zones can be created within a SpaceWise group and each luminaire
can be part of just one zone.
All luminaires within the zone will react the same way to any sensor in the
zone. That is, all luminaires in the zone will simultaneously increase light
level upon motion detection or will simultaneously dim down to background
level when there is no motion.
Luminaire
Luminaire
Point to any of
the luminaires
in the group and
press "mode."
While the LED is still
blinking red, enter the
number for the preferred
mode (see list at step 5).
Point to any of
the luminaires
in the group,
press "send."
Lock the group,refer to
step 4e.
• After locking lighting
group is operational in
selected mode.
If unsure about mode selection or remote blinking status then wait
for the remote blinking to stop and redo step 5b.
Zones can only be created within a group. A group needs be created
first as per the instructions in section 4.
Red LED on
remote will
start blinking.
mode
The luminaire will
O )))
FLASH twice and
group light level will
go to 50%.
Group
1
Zone
2
II
Luminaire
3
5
4
23
Advertisement
