Contents 1 Your universal remote Introduction Overview of the universal remote Supported devices 2 Get started Insert batteries (not included) Set up the universal remote 3 Notice Disposal of your old product and battery 4 Service and support Frequently asked questions Need help?
1 Your universal remote Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome Introduction With the universal remote, you can operate up to 8 different devices. Overview of the universal remote a INPUT: select available source inputs (antenna, cable, etc.).
c GUIDE: displays the program guide. INFO: displays on-screen channel information. MENU: menu on or off. BACK: exit from the menu. OK: confirm your selection. : up/down/left/right. d VOL+/-: adjust the volume. CH+/CH-: go to the next/previous channel. : mute LAST: return to the previous tuned channel.
2 Get started Insert batteries (not included) Warning • Check the battery polarity when inserting in the battery compartment. Incorrect polarity may damage the product. Caution • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.
Set up the universal remote You must first set up the universal remote before operating your devices. Manual registration Switch on your device. Press and hold the device selection button (e.g. TV) for 5 seconds until the red LED is on. Look up the 5-digit code for your brand in the code list.
Page 8
Enter the first 5-digit code using the digit buttons. If the light is off, a valid code is saved. Otherwise, the light will flash once, and then remains on for code re-entry. Operate the device with the universal remote. If your device responds correctly, it means you have entered the right code.
Page 9
Auto registration Switch on your device. Press and hold the device selection button (e.g. TV) for 5 seconds until the red LED is on. Point at your device with the universal remote. Then press and release to start searching the code for your brand. A different infrared signal is sent every 2 seconds as the universal remote searches, indicated by a red flash.
Page 10
When the device is off, immediately press and release OK to save the code. The red LED indicator will turn off. max. 20 minutes Operate the device with the universal remote. If your device responds correctly, it means you have saved the right code. Note •...
Warning: Changes or modifications made to this equipment not expressly approved by Gibson Innovations may void the FCC authorization to operate this equipment. Model number: SRP2018 Trade Name: Philips Responsible party: Gibson Innovations USA Inc.3070 Windward Plaza Suite F, Box 735 Alpharetta, GA 30005...
Please inform yourself about the local rules on separate collection of batteries. The correct disposal of batteries helps prevent potentially negative consequences on the environment and human health. Please visit www.recycle.philips.com for additional information on a recycling center in your area. Environmental information All unnecessary packaging has been omitted.
When calling our helpline, make sure to have the SRP2018 at hand when you call, so that our operators can help you determine whether SRP2018 is working properly. You will find our contact details at the end of this user manual. For online support, visit www.philips.com/support EN 11...
Page 14
Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. UM_SRP2018_27_EN_V1.0...