Initial Start-Up - Procedure For Proper Assembly; Install Power Supply - Dentsply Sirona SiroLaser Blue Operating Instructions Manual

Dentsply Sirona
Operating Instructions SiroLaser Blue
66 56 842 D3648
D3648.201.03.02.02 10.2018
Initial start-up – procedure for proper assembly
4.4

1. Install power supply

2. Assemble handpiece and single-use fiber tips or therapy rods
3. Install wireless foot control – optional
4. Install remote interlock – optional
5. Start SiroLaser Blue for the first time
4.4.1 Install power supply
1. Connect the power cable to the DC IN socket at the back of the
SiroLaser Blue.
2. Please make sure to switch on the switching power supply.
Ä The green LED on the power supply lights up.
CAUTION
The SiroLaser Blue may only be operated with the Sinpro
MPU101-106 power supply. Operation with other power supplies may
result in failure or destruction of the laser unit. If any power supply
other than the one recommended is used, the approval of the entire
unit automatically becomes void and the warranty granted by
Dentsply Sirona expires.
The use of any power supplies other than the one recommended may
cause overheating and failure of the laser unit or damage of batteries.
The SiroLaser Blue is supplied with a rechargeable battery and
therefore can be used without connected power cable. The status of the
rechargeable battery and whether the power cable is actually connected
will be always displayed on the touch screen.
NOTE
There will be a warning if the rechargeable battery reaches a low level
of capacity.
This is indicated by the red LED bar on the top of the control unit.
The SiroLaser Blue is fully functional and can be run while charging the
battery.
➢ Charge the battery completely.
NOTE
The rechargeable battery must be fully charged regularly. After six
months of non-charging the rechargeable battery might reduce its
loading capacity.
4.4 Initial start-up – procedure for proper assembly
4 Installation
27