Maintenance Menu Operations - Sony XDCAM PDW-1500 Operation Manual

Item
SDI2 SUPER
For details about OTHERS items other than the above,
refer to the Maintenance Manual.

8-4-2 Maintenance Menu Operations

This section describes the indications in the maintenance
menu and how to change the settings.
To display a menu item setting
First change the switch setting within the unit, then carry
out the following operations.
For information about how to change the switch setting
within the unit, see page 120.
SG DATA SG DATA SG DATA
ACCESS ANA SDI ANA SDI ANA SDI
AE8/EBU AE8/EBU AE8/EBU
dB dB dB
OVER OVER
0 0 0
NETWORK -12 -12 -12
LOCAL -20 -20 -20
REMOTE -30 -30 -30
-40 -40 -40
MONITOR
-60 -60 -60
CH- 15 CH- 26 CH-
L
MIX
R AUDIO
MONITOR SEL METER SEL INPUT CH
ALL/CH-1
VARIABLE
REC
PRESET
PB
PHONES
PREV PLAY
TOP F REV F FWD
1
Press the MENU button.
The menu appears in the time data display.
2
Hold down the COUNTER SELECT button, and press
the SET button.
In the time data display, first "MAINTE MENU"
appears momentarily, and then the item group name
appears.
To change the item group
Use the F/f buttons.
3
Press the g button.
126
8-4 Maintenance Menu
Setting
Select whether to output superimpose characters to the SDI OUT2 (SUPER) connector.
ON: Output.
OFF: Do not output.
1
EJECT
REMOTE [9P iLINK]
SG DATA EDIT KEY INH ALARM
ANA SDI
INPUT
AE8/EBU VITC VIUB COUNTER VITC REC INH
i.LINK
dB
OVER OVER
0 SDI
CMPST
-12 Y-R,B
-20 SG
-30 HOURS MINUTES SECONDS FRAMES
-40 MONITOR
-60 1/2 3/4 AUDIO 625 IMX[50 40 30]
37 CH- 48 5/6 7/8 4 8 CH 18 24 BIT 525 DVCAM
SHIFT
VIDEO COUNTER SYS MENU
INPUT SEL INPUT SEL SELECT HOLD MENU
SUB THUMB
CH-2 CH-3 CH-4
CLIP NAIL SET RESET
CLIP ESSENCE S.SEL
MARK1
MENU MARK
NEXT
STOP REC
IN OUT
END
MARK2
2 2,3 3,4
OTHERS
The item name appears.
Flashes to indicate that there is a next level (sub-item/setting).
To return to the item group
Press the G button.
To change the menu item
Use the F/f buttons.
4
Press the g button.
The setting value appears.
To return to the menu item
Press the G button.
When there is a sub-item
Repeat step 3.
To display the menu on a monitor
Connect the monitor to the VIDEO OUT 2 (SUPER)
connector or SDI OUT 2 (SUPER) connector of this unit,
and carry out the same operation as in the previous item.
The currently selected menu item is shown in reverse
video on the monitor.
To change the setting of a menu item
To change the setting of the currently displayed menu
item, carry out the following operations.
For details of changing settings of network-related items,
see the next item, "To change network settings."