Using Umid Data - Sony XDCAM PDW-1500 Operation Manual

S2202, switch 4
3
Replace the cover.
Note
Tighten the screws firmly.
To enable extended menu display in the
maintenance menu
Carry out the following operations.
SG DATA SG DATA SG DATA SG DATA EDIT REMOTE [9P iLINK]
ACCESS
ANA SDI ANA SDI ANA SDI ANA SDI INPUT
VITC VIUB
AE8/EBU AE8/EBU AE8/EBU AE8/EBU
i.LINK
dB OVER dB OVER dB OVER dB OVER
0 0 0 0 SDI
CMPST
NETWORK -12 -12 -12 -12 Y-R,B
SG
LOCAL -20 -20 -20 -20
REMOTE HOURS
-30 -30 -30 -30
-40 -40 -40 -40 MONITOR
MONITOR
-60 -60 -60 -60 1/2 3/4 AUDIO
15 26 37 48 5/6 7/8 4 8 CH 18 24 BIT
CH- CH- CH- CH-
L
MIX
R AUDIO VIDEO COUNTER
MONITOR SEL METER SEL INPUT CH INPUT SEL INPUT SEL
ALL/CH-1 CH-2 CH-3 CH-4
VARIABLE
REC
PRESET
PB
PHONES NEXT
PREV PLAY STOP
TOP F REV F FWD END
2
1
Press the MENU button.

8-3-3 Using UMID Data

To perform operations from interviewing to editing
effectively and to detect audio-visual materials easily
when reusing them, metadata that provides additional
What is a UMID?
The UMID (Unique Material Identifier) is a unique
identifier for audio-visual material defined by the
SMPTE330M-2003 standard.
The UMID may be used either as the 32-byte Basic UMID
or as the Extended UMID, which includes an additional 32
bytes of Source Pack to make a total 64 bytes.
For details, refer to SMPTE 330M.
1 8
EJECT
KEY INH
ALARM
COUNTER VITC REC INH
MINUTES SECONDS FRAMES
625 IMX[50 40 30]
525 DVCAM
SYS MENU SHIFT
SELECT HOLD MENU
SUB THUMB
CLIP NAIL SET RESET
CLIP ESSENCE S.SEL
MENU MARK MARK1
REC
IN OUT
MARK2
3,5,7 4,6
The menu appears in the time data display.
2
Hold down the COUNTER SELECT button, and press
the SET button.
In the time data display, first "MAINTE MENU"
appears momentarily, and then the item group name
appears.
3
Using the F/f buttons, display "Setup" in the time
data display.
4
Press the g button.
5
Using the F/f buttons, display "> Extended" in the
time data display.
6
Press the g button.
The time data display shows the current setting (">>
DISABLE").
7
Press the f button, to display ">> ENABLE" in the
time data display.
8
Press the SET button.
When you next display the menu and change the item
display, the extended menu will appear after the basic
menu.
information is recorded along with audio-visual data. As
one of application of metadata, the UMID (Unique
Material Identifier) is internationally standardized.
121
8-3 Extended Menu