Sony XDCAM PDW-1500 Operation Manual page 136

When the unit is powered on
Message in time Display
data display
condition
MENU Ver.UP on, limit, off
ILL. SETUP! on, limit, off
Exchg batt! on, limit, off
a) With respect to setting of basic menu item 016
When a disc is inserted
Message in time Display
data display
condition
Unknown FS! on, limit, off
No FS! on, limit, off
ILL. Disc! on, limit, off
Salvage NG on, limit, off
525/60 Clip on, limit
625/50 Clip on, limit
IMX50 Clip on, limit
IMX40 Clip
IMX30 Clip
DVCAM Clip
4CHx24 Clip on, limit
8CHx16 Clip
No Support! on, limit, off
136
9-3 Alarms
Description
a)
Setup menu settings were reset,
because this unit was upgraded.
Setup menu data is invalid, or data
recalled with the maintenance menu
item "SETUP MAINTENANCE" –
"AUTO BANK RECALL" is invalid.
NVRAM battery is exhausted.
Description
a)
The loaded disc was formatted by an
unknown file system.
The file system cannot be detected.
An unsupported disc was inserted.
Recovery of disc contents (salvage)
failed.
A disc recorded in NTSC format was
inserted when this unit is in 625 line
mode (PAL system).
A disc recorded in PAL format was
inserted when this unit is in 525(U) or
525(J) line mode (NTSC system).
The recording format of the loaded disc
differs from the format specified with
basic menu item 031 "RECORDING
FORMAT."
The number of channels and quantizing
bits of the loaded disc differ from the
specifications of maintenance menu item
"AUDIO CONFIG" - "DATA LENGTH."
A disc recorded in an unsupported
recording format was inserted.
Action
Reset the setup menu items.
See 8-2-2 "Basic Menu Operations" (page
105) and 8-3-2 "Extended Menu
Operations" (page 120) for information
about making setup menu settings.
Maintenance menu item "SETUP
MAINTENANCE" - "SAVE MENU DATA/
LOAD MENU DATA" (see page 125) can be
used to temporarily back up and restore the
current menu settings.
Reset the items in the setup menu.
It is time to exchange the battery on the
board. Contact your Sony service
representative.
Action
Eject or format the disc.
See 3-5-5 "Formatting a Disc" (page 47) for
more information about formatting.
Eject the disc.
See 3-5-7 "Handling of Discs When
Recording Does Not End Normally
(Salvage Function)" (page 47).
Use a disc recorded with the PAL system.
Use a disc recorded with the NTSC
system.
To record on the disc, change the setting of
basic menu item 031.
See 8-2-2 "Basic Menu Operations" (page
105) about how to change this setting.
To record on the disc, change the setting of
maintenance menu item "AUDIO CONFIG"
- "DATA LENGTH."
See 8-4-2 "Maintenance Menu Operations"
(page 126) about how to change this
setting.
Use a disc recorded in the MPEG IMX or
DVCAM format.