Installation Manual
iSiteC BTS3601C CDMA Base Station
4.2.2 Installing GPS Antenna Support
In terms of varied installations, there are different supports available.
I. On tower
Figure 4-2 illustrates the support installed on tower.
(1) Adjustable clamp
Figure 4-2 Antenna support on tower
Installation procedure is as follows:
1)
Unscrew the bolts on the fixed clamps and remove the adjustable clamps;
2)
Place the antenna support in the right position on the tower so that the tower angle
steel is between the fixed clamp and the adjustable clamp;
3)
Fix the support on the tower with fasteners including bolts, plain washers, spring
washers and nuts;
4)
Insert the antenna support lever into the support and put it through the bolt holes.
Tighten the bolts to fix the antenna support.
Figure 4-3 illustrates an installed antenna support on tower.
4 Installing Satellite Synchronization Antenna and Feeder System
(2) Fixed clamp
(3) Support
4-3
Hardware Installation
(4) M8 bolt