C Making Connectors; Overview; Making 7/16 Din Connector And N Connector For Jumper - Huawei iSiteC BTS3601C Installation Manual

Installation Manual
iSiteC BTS3601C CDMA Base Station
C.1 Overview
Preparation of connectors is a very important job during the installation of antenna and
feeder system. Normative and correct operation will directly affect the performance of
the antenna and feeder system. In this chapter, we respectively introduce the
preparation of the DIN connector and N connector of antenna and feeder for the
reference of project installation.
& Note:
What described in this section is for reference only. The preparation of connectors for antenna and feeder
should be follow the auxiliary installation instruction for connectors in the actual installation.
C.2 Making 7/16 DIN Connector and N Connector for Jumper
Caution:
The following takes the preparation of 7/16 DIN connector as an example. N connector is prepared in the
same way.
I. Tools required
Spanners (one is 19mm and the other is 22mm), fast cable cutter, fast cable stripper,
safety knife, electric blower, diagonal pliers, nipper pliers, pliers, file, brush and ruler
are all required.
II. Making connectors
1) Get the required tools ready and put them in a convenient place.
2) Cut the jumper to be mounted with a connector to the accurate length.

C Making Connectors

C-1
Hardware Installation
C Making Connectors