Huawei iSiteC BTS3601C Installation Manual page 66

Installation Manual
iSiteC BTS3601C CDMA Base Station
Figure C-9 Fitting torque
12) Be sure to test the connector after it is made. It can only be put into use after it
passes the test.
Caution:
1. Pay attention to safety during the preparation. Improper operation of sharp-edged tools can cause
human injury.
2. Be sure to clean up the feeder remainders to avoid copper scales from mixing up with the connector,
which could adversely affect the performance of the antenna and feeder system.
C.3 Making 7/16 DIN Connector and N Connector for 7/8
Feeder
Caution:
The following takes the preparation of N connector as an example. 7/16 DIN connector is prepared in the
same way.
C-5
Hardware Installation
C Making Connectors