Huawei iSiteC BTS3601C Installation Manual page 67

Installation Manual
iSiteC BTS3601C CDMA Base Station
I. Tools required
Spanners (one is 19mm and the other is 22mm), fast cable cutter, fast cable stripper,
safety knife, electric blower, diagonal pliers, nipper pliers, pliers, file, brush and ruler
are all required.
II. Making connectors
1) Get the required tools ready and put them in a convenient place.
2) Straighten the end of the feeder to be mounted with a connector.
3) Cut the feeder with a fast cable cutter. The cutting surface should be smooth.
4) Cut the cable skin at 51mm away from the connector with the fast cable cutter and
the safety knife, as shown in Figure C-10.
5) Add O-ring and apply proper amount of grease on it, as shown in Figure C-11.
Figure C-10 Cutting cable skin
Figure C-11 Adding O-ring and applying grease
6) Add fixing nut, as shown in Figure C-12.
7) Place spring ring and fix it in the outer conductor trough of the feeder, as shown in
Figure C-13.
C-6
Hardware Installation
C Making Connectors