Huawei iSiteC BTS3601C Installation Manual page 49

Installation Manual
iSiteC BTS3601C CDMA Base Station
Upon completion of all hardware installation, check the installation including the
following aspects: overall check, power-on check, environment condition check and
system commissioning.
5.1 Overall Check
5.1.1 Checking Equipment Installation
All the equipment should be steady and neat in appearance when installed.
l
All the bolts and nuts are fastened. And plain washers and spring washers are
l
applied under all the nuts with the plain washer under the spring washer.
There should be no missing or damaged parts on the equipment, and all the
l
cables should be intact.
The rack interior should be cleaned. Fingerprints and smudges left during the
l
installation should be cleaned. There should be no dust in the rack.
5.1.2 Checking Cable Connection
Power cables should be well connected. The connector should not be loose or
l
damaged. And there should be no scratch or fissure on the power cable skin.
Check whether the contact of the grounding cable is good.
l
Check whether the trunk cable connections are secure and correct.
l
All the cables should be secure. Do not over-strain the cables running round the
l
corner. Cables and fibers should run in straight and smooth courses without any
cross. Cables and fibers in the same direction should be bundled up. The cable
layout should be neat and tidy with the same bundling space. Signal cables cannot
be bundled with power cables and grounding cables.
There should be no damage to the skin of all the cables.
l
5.1.3 Checking Lightning Protection Grounding
I. Checking outdoor grounding
Outdoor grounding check includes the following aspects:
Outdoor grounding bar should be connected to the counterpoise with grounding
l
bus. DO NOT connect the outdoor grounding bus to the grounding flat steel of the
feeder lightning arrester.
5 Installation Check
5-1
错 误 未 找 到 引 用 源 错 误
Hardware Installation
未 找 到 引 用 源