Installation To Double Wood Stud Wall - NEC WMK-3257 Installation And Assembly Manual
Flat screen wall mount for models: aspv32, aspv40, e321, e421, e461, lcd3210, lcd3215, lcd4020, lcd4215, lcd4615, lcd4620, lcd5220, lcd5710, m40, m46, p401, p461, p521, p551, s401, s461, s521, sc40, sc46, v321, v421, v461, x431bt, x461hb, x461un, e324, ma
Advertisement
Installation to Double Wood Stud Wall
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that the
wood studs are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8".
Wall plate (A) can be mounted to two studs that are 16" apart. Use a stud fi nder to locate the edges of the studs.
1
Use of an edge-to-edge stud fi nder is highly recommended. Based on their edges, draw a vertical line down each
stud's center. Place wall plate on wall as a template. Level plate, and mark the center of the four mounting holes.
Make sure that the mounting holes are on the stud centerlines. Drill four 5/32" (4 mm) dia. holes 2-1/2" (65 mm)
deep. Make sure that the wall plate is level, secure it using four #14 x 2.5" wood screws (D) as shown in fi gure 1.2.
Skip to step 2 on page 6.
D
A
WARNING
4 of 7
STUD
fi g. 1.1
ISSUED: 03-26-10 SHEET #: 125-9106-6 12-11-14
Advertisement
