Download Print this page

To Wood Joist Finished Ceilings, Exposed Wood Joists Or Wood Beam Ceilings - NEC NP-P350W Installation And Assembly Manual

Universal ceiling mount
Hide thumbs Also See for NP-P350W:

Advertisement

Installation To Wood Joist Finished Ceilings, Exposed Wood Joists, or
Wood Beam Ceilings
• Tighten wood screws (F) so that ceiling plate (G) is firmly attached, but do not overtighten. Overtightening can damage
the screws, greatly reducing their holding power.
• Never tighten in excess of 80 in • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder is
highly recommended.
1
Drill two 5/32" (4 mm) dia. holes to a minimum
depth of 2.5" (64 mm). Attach ceiling plate (G)
with two #14 x 2.5" (6 mm x 65 mm) wood
screws (F) as shown using 3/8" (10 mm) socket
wrench.
Skip to step 2.
WARNING
• It is the responsibility of the installer to verify that the
supporting surface will safely support the combined
load of all attached hardware and components.
IMPORTANT: Be sure to drill holes into the
joist CENTER!
WOOD
JOIST
Visit the Peerless Web Site at www.peerlessmounts.com
WARNING
CEILING
H
H
G
F
F
WOOD
JOIST
G
For optional Cord Management,
install two spacers (H) between ceiling
plate (G) and ceiling.
4 of 9
For customer care call 1-800-729-0307 or 708-865-8870.
CEILING
F
F
ISSUED: 04-11-06 SHEET #: 055-9458-6 09-25-09

Advertisement

loading