Sony MZ-M200 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual page 72

Message
CANNOT SET
CHARGE
+5°C–+35°C/41F–95F
DATA SAVE
DC IN TOO HIGH
DISC FULL
END
ERROR
FORMAT
ERROR DISC
HOLD
IN MENU
72
Case and/or corrective action
 You selected "REC Mode" or "Group REC" in the recorder menu or
"SpeedCtrl" in the remote menu while recording or in recording pause.
 You selected "Time Mark" in the menu during digital recording or in
recording-pasue.
 You selected "REC Level" in the menu while the recorder is paused during
synchro-recording.
 You selected "REC Level" while the recorder is not stopped or in
recording-pause.
 You selected "MIC AGC" while "REC Level" in the menu has been set to
"Manual".
 You tried to charge the rechargeable battery at a place with a temperature
outside the specified range for the recorder. Charge the battery at a
temperature of +5° C (+41° F) to +35° C (+95° F).
 The recorder is writing information to the system file, such as the recorded
data or editing information. Wait until this process is completed. (Do not
expose the recorder to physical shock, nor disrupt power supply.)
 Voltage of the power supply is too high (The supplied AC power adaptor or
the AC power cord is not used). Use the supplied AC power adaptor or the
AC power cord.
 You tried to record on a disc that does not have enough space.
 The recorder reached to the end of the last track in the selected play mode
while playing or moving the jog lever toward FF ( on the remote). You
pressed the jog lever (/ENT) (/ENT on the remote) at the end of the
last track on the disc.
 There is a built-in malfunction in the system. While operating, the recorder
received a mechanical shock, too much static, abnormal power voltage
caused by lightning, etc. Disconnect all the power sources and the USB
cable. Leave the recorder for about 30 seconds and connect the power
source.
 A disc with a format that the recorder does not support was inserted. Insert
a standard MD or a disc used in Hi-MD mode.
 A disc formatted on the computer without using the SonicStage software
was inserted. When formatting a disc on the computer, make sure to use the
SonicStage software.
 The recorder is locked. Slide HOLD against the arrow to unlock the
recorder (  page 15).
 You operated the remote while selecting a menu on the recorder. Do the
setting on the recorder. You operated the recorder while selecting a menu on
the remote. Do the setting on the remote.