5
Confirm that the operation lamp is off (), and then press and slide REC on the
recorder ().
The operation lamp lights up in red and recording starts.
If you insert a previously recorded disc, the recording starts after the existing contents.
The operation lamp
Basic recording operations
To
Stop
Pause
Remove the disc
Adding track marks
* A track mark is added at the point where you press
remainder of the track will be counted as a new track.
REC
Press
Press · CANCEL. (The operation lamp disappears.)
Press *. (The operation lamp flashes in red.) Press again to resume
recording.
Press · CANCEL and open the lid. (The lid does not open until
"SystemFILE WRITING" disappears from the display and the operation
lamp stops flashing.)
Press T MARK. (The operation lamp disappears for a moment.)
again to resume recording while pausing; thus the
33