Connecting The Recorder To Your Computer - Sony MZ-M200 Hi-MD Music Transfer Version 1 for Mac (User Manual) Operating Instructions Manual

Connecting the recorder to your computer

Connect the recorder to your computer as follows.
Note
When using Windows ME or Windows 98SE
• If you connect the recorder to the computer with the disc mode on the recorder set to "Hi-MD" (factory
setting), and then insert a 60/74/80-minute standard disc, the operation mode of the disc may automatically
change to Hi-MD mode even if you do not record anything.
• When you disconnect the USB cable, the message "Unsafe Removal of Device" appears in the computer
display. This is not a problem. Merely click "OK" to make the message disappear.
Power (bus power) is supplied from the USB port of the computer so that the recorder can be used
without power being supplied from the battery.
1
Insert a disc into the recorder.
2
Make sure the recorder is stopped and HOLD is released.
3
Connect the recorder to the computer through the USB cable.
4
Check the connections.
If all connections have been correctly made, the display window appears as follows.
"Hi-MD" or "MD" appears, depending on the operation mode.
USB cable
To the USB cable
connecting jack
Computer
To the USB port
21