A-4 Using The Distributed Sensor Unit; Models Of Sensor Amplifier Units Connectable To A Distributed Sensor Unit - Omron E3NW-CCL User Manual

A Appendices

A-4 Using the Distributed Sensor Unit

A-4-1 Models of Sensor Amplifier Units Connectable to a Distributed
Sensor Unit
This section describes the models and features of the Sensor Amplifier Units that can be connected to
an E3NW-DS Distributed Sensor Unit.
Type
Smart Fiber Amplifier Unit
Smart Laser Amplifier Unit
Smart Laser Amplifier Unit (CMOS)
Contact-type Smart Sensor
Smart Fiber Amplifier Unit
Smart Fiber Amplifier Unit
Smart Amplifier Separation
Proximity Unit
Smart Analog Input Unit
Smart Analog Input Unit
Smart Analog Input Unit
* The E9NC-TA0 is supported from E3NW-CCL Version 1100, and the E3NX-MA0, E2NC-EA0, and
E9NC-AA0/VA0/VD0 are supported from E3NW-CCL Version 1160.
You can check the version with read command "B". (Refer to page A-2)
A - 22
Model number
A standard, easy to operate and easy to configure
E3NX-FA□0
Fiber Amplifier Unit.
A Laser Sensor that can reliably detect workpieces
E3NC-LA0
even with a small spot diameter
A CMOS-type Laser Sensor that can reliably detect
E3NC-SA0
steps.
E9NC-TA0 A durable contact-type sensor.
E3NX-MA0 Fiber Amplifier with Light Emission/Reception
Fiber Amplifier with Near Infrared Light
E3NX-FAH0
Emission/Reception
E2NC-EA□0 Proximity Sensor Amplifier
E9NC-AA□0 Current (4 to 20 mA) Input Amplifier
E9NC-VA□0 Voltage (1 to 5 V) Input Amplifier
E9NC-VD□0 Voltage Differential (−2 to 2 V) Input Amplifier
E3NW-CCL CC-Link Digital Sensor Communications Unit User's Manual (E431)
Features