3 Basic Application Procedures
3-2
Setting and Wiring Hardware
This section describes how to set up and wire the CC-Link master, Communications Units, and power
supplies.
3-2-1
Mounting and Setting Up the CC-Link Master
Mount the CC-Link master at the specified location and set the unit number and other settings. For
details, refer to the manual for your CC-Link master.
3-2-2
Mounting and Setting Communications Units
Mount each Communications Unit and Distributed Sensor Unit in the designated locations, then set the
station numbers and other settings. For details, refer to the following items.
Installation
4-1 Mounting and Removal.
Hardware Settings
5-3-2 Setting Switches on page 5-6
Set the baud rate, operating mode, and station number.
3-2-3
Wiring the Communications Cables
Connect communications cables to the CC-Link master, Communications Units, and Distributed Sensor
Units. Refer to 4-2 Wiring the CC-Link Network for wiring procedures.
3-2-4
Connecting the Power Supplies
Connect the Unit power supply to the CC-Link master, slaves, and the Distributed Sensor Units.
Connect the I/O power supply unit to each slave as required.
For connection method details, refer to 4-3 Connecting the Unit Power Supply or refer to the wiring
diagrams for each slave.
3-2-5
Connecting the Sensors
Connect the Sensor Amplifiers to the Sensors. For connection methods, refer to your Sensor Amplifier
manual.
Reference
When using the Distributed Sensor Unit, refer to A-4 Using the Distributed Sensor Unit on page
A-22 as well.
3 - 4
E3NW-CCL CC-Link Digital Sensor Communications Unit User's Manual (E431)