Nibe F370 Installer Manual page 60

USB service outlet
F370 is equipped with a USB socket in the display unit.
This USB socket can be used to connect a USB memory
to update the software, save logged information and
handle the settings in F370.
INDOOR CLIMATE
HEAT PUMP
When a USB memory is connected a new menu (menu
7) appears in the display.
58 Chapter 9 | Service
HOT WATER
USB
INFO
USB 7
update firmware
logging
manage settings
Menu 7.1 - update firmware
update firmware7.1
start updating
choose another file
This allows you to update the software in F370.
NOTE
For the following functions to work the USB
memory must contain files with software for
F370 from NIBE.
The fact box at the top of the display shows information
(always in English) of the most probable update that
the update software has selected form the USB
memory.
This information states which product the software is
intended for, the software version and general inform-
ation about them. If you wish to select another file than
the one selected, the correct file can be selected by
"choose another file".
start updating
Select "start updating" if you want to start the update.
You are asked whether you really want to update the
software. Respond "yes" to continue or "no" to undo.
If you responded"yes" to the previous question the
update starts and you can now follow the progress of
the update on the display. When the update is com-
plete F370 restarts.
NOTE
A software update does not reset the menu
settings in F370.
NOTE
If the update is interrupted before it is com-
plete (for example power cut etc.) the software
can be reset to the previous version if the OK
button is held in during start up until the green
lamp starts to illuminate (takes about 10
seconds).
NIBE™ F370