EDAN SE-3 Series User Manual page 70

SE-3&SE-300 Series Electrocardiograph User Manual Troubleshooting
Reload the paper in the paper tray, close the paper casing firmly. If the problem still exists, please
contact the manufacturer or the local distributor for further disposal.
Q5: I pressed the PRINT/STOP key, but the ECG didn't start printing, what's wrong with it?
A5: Please check whether there is any error information displayed on the screen.
If the hint Paper? or PaperErr is shown on the screen, please deal with it according to the
above-mentioned measures.
If the hint Transfer is shown on the screen, which means that the ECG is transmitting the data to
the PC, please wait a few seconds. You can start the printing after the data has been transmitted.
If the problem still exists, please contact the manufacturer or the local distributor for further
disposal.
3) Transmitting Problems
Q1: The ECG doesn't respond to any keys after a long time of transmitting. It transmits nothing
for there is no new data appearing on the interface of the PC software. What should I do?
A1: Some error may occur during the transmission course, for example, the connection between
the ECG and the net cable may loosen. In this case, please restart the ECG. If it doesn't work,
please restart the PC.
If the problem still exists, please contact the manufacturer or the local distributor for further
disposal.
- 63 -