Emerson FieldQ Series Product Data Sheet page 15

Product data sheet
1.603.03 Rev. 1 Page 2 of 2
November 2018
Insert Removal tool
Description
The standard FieldQ actuators are equipped with Square-Drive
inserts according ISO5211. When assembled at the factory,
the inserts are press-fitted on an edge in the pinion bottom. In
order to be able to replace these standard inserts, these insert
removal tools will help you to easily remove the standard insert
from the pinion bottom.
Availability
The insert removal tools are available in two versions and can be
used up to actuator size 600. For larger actuator sizes, up to size
2500, it is recommended to use a generic pulley puller.
Intended use:
These insert removal tools are intended to be used just before
the installation of the actuator onto a valve and where the
default insert needs to be replaced by an insert with a different
size or shape.
Operation:
The insert removal tools are equipped with 3 square bits that
fit exactly in the insert square of the actuator. Make sure the
square bits are as high as possible on the threaded rod. Then
you can insert (1) and rotated 45° (2) the tool and one of the
square bits will hook under the insert.
The knob (3) on the tool can now be rotated until the insert get
loose (4) and it can be removed from the pinion's bottom.
Specifications:
Tool part nr.: Squares:
VA590.00.001 11, 14 and 17
VA590.00.002 19, 22 and 27
Materials:
Body, Knob and bits:
FieldQ
Copyright © Emerson. The information in this document is subject to change without notice. Updated data sheets can be obtained from our website
www.emerson.com/fieldq or from your Emerson Automation Solutions - Actuation Technologies Center:
America's: +1 281 477 4100 Europe: +36 22 53 0950 Asia/Pacific: +65 67 77 8211
Actuator sizes:
25, 40, 65, 100, 150
100, 150 200, 350, 600
Carbon steel, Zinc Plated
2
45°
1
3
FieldQ
4