The Rear Ports Of Bipac 8501; Cabling - Billion BIPAC 8501 User Manual

The Rear Ports of BiPAC 8501

Port
Power Switch
1
PWR
2
3 RESET
LAN
4 1X — 4X
(RJ-45 connector)
CONSOLE
5
LINE
6

Cabling

One of the most common causes of problems is bad cabling or SHDSL line(s). Make sure that all
connected devices are turned on. On the front of the product is a bank of LEDs. Verify that the LAN Link
and SHDSL line LEDs are lit. If they are not, verify that you are using the proper cables.
5
6
Power ON/OFF switch
Connect the supplied power adapter to this jack.
To be sure the device is being turned on
button for:
1-3 seconds: quick reset the device.
6 seconds above, and power off, power on the device:
restore to factory default settings. (Cannot login to the router
or forgot your Username/Password.
more than 6 seconds).
Caution: After pressing the RESET button for more than 6 seconds,
to be sure you power cycle the device again.
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the
four LAN ports when connecting to a PC or an office/home
network of 10Mbps or 100Mbps.
Connect a PS2/RS-232 cable to this port when connecting to a
PC's RS-232 port (9-pin serial port).
Connect the supplied RJ-11 ("telephone") cable to this port
when connecting to SHDSL line.
SHDSL VPN Firewall Bridge/Router
3
4
Meaning
1
2
press RESET
Press the button for
11