The Rear Ports Of Bipac 8500 / 8520 - Billion BIPAC 8501 User Manual

The Rear Ports of BiPAC 8500 / 8520

*6
＊
Port
Power Switch
1
PWR
2
3 RESET
LAN
4 1X — 4X
(RJ-45 connector)
CONSOLE
5
LINE
1X — 2X
6
(RJ-11
connector
5
Only the BiPAC 8520 has two Line jack ports. BiPAC 8500 has one.
Power ON/OFF switch
Connect the supplied power adapter to this jack.
To be sure the device is being turned on
1-3 seconds: quick reset the device.
6 seconds above, and power off, power on the device: restore to
factory default settings. (Cannot login to the router or forgot your
Username/Password. Press the button for more than 6 seconds).
Caution: After pressing the RESET button for more than 6 seconds, to be sure
you power cycle the device again.
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the four LAN
ports when connecting to a PC or an office/home network of 10Mbps or
100Mbps.
Connect a PS2/RS-232 cable to this port when connecting to a PC's
RS-232 port (9-pin serial port).
Connect the supplied RJ-11 ("telephone") cable to this port when
connecting to SHDSL line.
SHDSL VPN Firewall Bridge/Router
4
3
Meaning
press RESET button for:
1
2
10