Basic Recording; Inserting Blank Spaces - Aiwa CX-NMT720 Operating Instructions Manual

This section explains how to record from the tuner, CD player, or
external equipment.
l__~_l
3
Preparation
"
Use Type I (normal) and Type II (high/CrOz) tapes for recording.
Set the tape to the point where recording will start.
1
2
3
4
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press REV MODE to select the reverse mode.
To record on one side only, select 1.
To record on both sides, select => or (1).
Press function (CD, TUNER, VIDEO/AUX or MD)
and prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To
record from a radio broadcast,
press TUNER and tune
in to a station.
To record from a connected
source,
press VIDEO/AUX or
MD.
Press REC/REC MUTE to start recording.
When the selected function is CD, playback and re;ording
start simultaneously.
When recording from a connected source, start playback of
the source.
To
stop recording,
press .
To pause recording,
press II. (Applicable when the source is
TUNER, VIDEO/AUX or MD) To resume recording, press it again.
To start recording with the remote control
First press /0
REC/REC MUTE, and then
press 4> within 2
seconds.
Sound adjustment during recording
The output volume and tone (except BBE and Rhythm play
function) of the speakers or headphones may be freely varied
without affecting the recording.
. ."-----..".". " ."... L,"w,*~****-*~m, *,!j!j
$*eiwa*w4@:---8 w% Jw$ww-w w*w*ww#mwx-&-. w& . .......-. %. -
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD.)
1
Press . REC/REC MUTE during recording or while in
recording pause mode.
~
on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2
Press II to resume recording.
To
insert a blank space of less than 4 seconds,
press
REC/REC MUTE again while ~ is flashing.
To insert blank spaces of more than 4 seconds,
after the deck
enters recording pause mode, press
REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is
added.
To erase a recording
Make sure the microphone is not connected to this unit and the
Rhythm play function (page 7) is canceled.
Set the microphone volume and the echo level to OFF (See page
23).
1
2
3
4
Insert
the tape to be erased into deck 2 and press TAPE DECK
1/2 to display '(TP 2".
Set the tape to the point where the erasure is to be started.
Set the reverse mode by pressing REV MODE.
Press REC/REC MUTE to start the erasure.
17
ENGLISH