Basic Recording - Aiwa NSX-SZ70 Operating Instructions Manual

This section explains how to record from the tuner, CD player, or
external equipment.
Preparation
¢ Use Type I (normal) and Type II (high/CrOz) tapes for recording.
¢ Set the tape to the point where recording will start.
1 Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
PUSH EJECT
=
2 Press REV MODE (DECK 2) to select the reverse
mode.
To record on one side only, select =
To record on both sides, select =) or C=).
3 Press DOLBY NR to turn Dolby NR on or off.
To record with DOLBY NR, turn on DO NR.
To record without DOLBY NR, turn off DO NR.
4 Press function (TUNER/BAND, VIDEO/AUX, CD o:
MD) and prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER/BAND arc
tune into a station.
To record from a connected source, press VIDEO/AUX o
MD.
5 Press @ REC/REC MUTE to start recording.
When recording from a connected source, start playback o
the source.
REC
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press Ml. -
To pause recording, press II. (Applicable when the source is
TUNER, VIDEO/AUX or MD.) To resume recording, press it again.
Sound adjustment during recording
The VOLUME control has no effect on recording, while the BBE
affects recording.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER/
BAND, VIDEO/AUX or MD.)
1 Press @ REC/REC MUTE during recording or while in
recording pause mode.
on the display flashes for 4 seconds and 4-second blank
space is made. Then, the deck enters the recording pause
mode.
2 Press Ill to resume recording.
To insert a blank space of less than 4 seconds, press @
REC/REC MUTE again while is flashing.
To insert blank spaces of more than 4 seconds, after the deck
enters recording pause mode, press @ REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is added.
NOTE)
If squealing or beating sounds occur when recording an MW or
LW broadcast, press MONO TUNER on the remote control while
pressing SHIFT until "BEAT 1" or "BEAT 2" is displayed, so as to
eliminate the noise.
MIC MIXING control to MIN (page 19).
1 Insert the tape to be erased into deck 2 and press TAPE/
DECK 1/2 to display "TP 2".
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing REV MODE (DECK 2).
4 Press @ REC/REC MUTE to start the erasure.
ENGLISH 15
RECO CD PLAYI