Connecting A Dvd Player; Listening To Dolby Digital Surround Sound - Aiwa CX-NMT720 Operating Instructions Manual

5.1 CH INPUT jacks of this unit support the DOLBY DIGITAL
SURROUND system.
Connect a DVD player with 5.1 CH output jacks to this unit using
cables with RCA phono plugs as follows;
DVD player'sjack " This unit's jack
5.1 CH OUTPUT FRONT (L, R), etc. 5.ICH FRONT (L,R)
5.1 CH OUTPUT REAR (L, R), etc. 5.1 CH REAR (L,R)
5.1 CH OUTPUT CENTER, etc. 5.1 CH CENTER
5.ICH OUTPUT SUB WOOFER, etc. 5.ICH SUB WOOFER
LINE OUT (L, R), etc. VIDEO/AUX
(See =.)
m
If the DVD is not connected to
VI DEO/AUX
jack of this unit;
- the spectrum analyzer dose not show the sound level of the
DVD player.
- the sound from the connected DVD player cannot be recorded.
To remove these limitations, connect the LINE OUT jacks of the
DVD player to VIDEO/AUX jacks of this unit besides connecting
to 5.ICH INPUT jacks. The signals through VIDEO/AUX jacks
enable the spectrum analyzer to work and the recording to be
done.
Refer also to the operating Instructions of the DV13 player.
c DOLBY DIGITAL SURROUND sound cannot be recorded in
any way.
.,. ., " ..%,.. :
..". .: ,,. ; ; :
. . . ,. . .
".. : . .. . .
LI'S'TENING """'"'TO"
DOLBY DIG ITA,L :
SURROUND SOUND
s
;Q',
.:*"
,
z;'
:8:
1
MANUAL @
SELECT
"*
?
< DOWN, O
-UP
When a DVD player is connected to the 5.1 CH INPUT Jacks, of
this unit, you can listen to DOLBY DIGITAL SURROUND sound,
which enables you to enjoy theater-quality sound in your home.
1
Press VI DEO/AUX/5.l CH repeatedly until "5.1 ch
IN" is displayed.
2 Start playing DOLBY DIGITAL SURROUND :sound
on the DVD player.
m
The DOLBY PRO LOGIC, BBE and the SURROUND are
automatically canceled when the 5.1 CH is selected.
Make sure the software played back with the connected DVD
player support the DOLBY DIGITAL SURROUND.
The function is changed from the 5.1 CH to the VI DEC) when;
m
- the headphones are plugged in.
- the MIC or ECHO level is changed.
- the Rhythm play function, the SURROUND system, the
DOLBY PRO LOGIC or the Karaoke function is turned on.
To adjust the sound levels of the center and surround
smeakers in DOLBY DIGITAL SURROUND
1
2
3
4
Press VIDEO/AUX/5.1 CH repeatedly until "5.1 ch IN" is
displayed.
Press MANUAL SELECT (TEST) repeatedly.
Speaker names appear in turn as follows;
r
UR (Speaker balance) x
CEN:
Center speaker —
3
S-R: Right surround speaker - S-L: Left surround speaker.
Press 4 DOWN or p UP to adjust the sound level while
"CEN", "S-L" or "S-R" is displayed.
Each level can be adjusted between -8dB and +7dB
Repeat steps 2 and 3 to adjust each speaker's sound level.
If the surround speakers or the center speaker level of the DOL13Y
DIGITAL SURROUND is changed, that of the SURROUND
system (page 11) and the DOLBY PRO LOGIC (page 21) is also
changed.
ENGLISH
28