Maintenance and Upgrade
Figure 50: Install the 100-G Network Module
Step 5
Gently push on the handle until it is fully seated on the network module faceplate and the module is fully seated in the
chassis.
Step 6
Tighten the captive screw on the left of the network module.
Step 7
Power on the chassis so that the new network module is recognized.
What to do next
Follow the procedures in the
that it has been discovered correctly by the Firepower 9300.
Remove and Replace the Power Supply Module
You can remove and replace the power supply module while the system is running. Make sure that at least
one of the power supply modules is active while hot-swapping.
Note
Replace power supplies immediately. Power supply blanks are not available.
FXOS Configuration Guide
Cisco Firepower 9300 Hardware Installation Guide
Remove and Replace the Power Supply Module
to connect to the network module and make sure
69