100-G Network Module (Double Wide) - Cisco Firepower 9300 Hardware Installation Manual

100-G Network Module (Double Wide)

Note You must upgrade your Firepower 9300 to firmware package 1.0.16 or later and have FXOS 2.3.2 or later
installed to support this network module.
Figure 12: FPR-NM-4X100G
1
3
5
7
100-G Network Module (Double Wide)
The following figure shows the front panel of the 100-G network module (FPRK9-DNM-2X100G). The
FPRK9-DNM-2X100G is a double-wide module that does not support hot swapping. The two ports are
numbered left to right.
Note Your Firepower 9300 must have firmware package 1.0.10 or later installed before you can use the Firepower
100-G network module.
Cisco Firepower 9300 Hardware Installation Guide
18
Power LED
Ethernet X/2
Ethernet X/4
Network activity LEDs
• Off—No connection or port is not in
use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing —Network activity.
Ethernet X/1
2
Ethernet X/3
4
6 Captive screw/handle
Overview